SL-1176-KIT  Assembly Instructions  updated 24 february'06 FET / Input Amplifier PCB  Below are two images of the FET / Input Amplifier PCB, blank and assembled, so you can check your work.  Because the resistors are 1%, metal film, Color Codes are provided for each part in the Table below.  The Schematic is now a PDF file.  Click here for the Parts List Spread Sheet.  NOTES No matter which transformer you choose -  Cinemag, Sowter or St. Ives 31267 - all have a 4:1 ratio suitable for our version of the 1176, so do not install R1 on the FET input PCB.  R1 is a "load" resistor that should only be used with the original 1176 front end -- a 600-ohm T-attenuator (Input Level) followed by a 1:1 transformer.  Using  R1 with the Neve style input circuit will reduce the sensitivity, change the gain structure and mess with your mind.

TABLE: Resistor Color Code for SL-1176-KIT FET / INPUT Amplifier PCB
 

Part Designation	Value	Color Code
R1	270	Red-violet-black-black
R2	27K	Red-violet-black-red
R3	10K	Brown-black-black-red
R4	1K	Brown-black-black-brown
R5	2.2M	Red-red-black-yellow
R6	2.2M	Red-red-black-yellow
R7	562K	Green-blue-red-orange
R8	182	Brown-gray-red-black
R9	182	Brown-gray-red-black
R10	150	Brown-green-black-black
R11	82.5	Gray-red-green-gold
R12	2k15	red-brown-green-brown
R13	1M	Brown-black-black-yellow
R14	22K	Red-red-black-red
R15	6K81	Blue-gray-brown-brown
R16	6K81	Blue-gray-brown-brown
RT1	100	This is a POT!